-------------------------------------------------- ---------------
Linux version 2.6.21-uc0 (root@VMdebian) (gcc version 3.4.4) #4 Wed Feb 11 05:37:37 CST 2009
CPU: NXP-LPC2478 [1701ff35] revision 5 (ARMv4), cr=a0234480
Machine: Future Electronics LPC2478 Micro-Blox Board
Ignoring unrecognised tag 0x00000000
Built 1 zonelists. Total pages: 8128
Kernel command line: root=/dev/mtdblock1 initrd=0x80200000 rootfstype=romfs console=ttyS0,115200N8
PID hash table entries: 128 (order: 7, 512 bytes)
LPC2XXX Clocking Fin=12000000Hz Fcco=288000000Hz M=11 N=0
Fcclk=72000000 PCLKSEL=55515555 11555455
Console: colour dummy device 80x30
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 32MB = 32MB total
Memory: 30124KB available (2020K code, 225K data, 104K init)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NetWinder Floating Point Emulator V0.97 (double precision)
JFFS2 version 2.2. (NAND) (SUMMARY) (C) 2001-2006 Red Hat, Inc.
io scheduler noop registered (default)
lpc2478fb: smem_len = 153600
lpc2478fb: line_length = 480
lpc2478fb: lcd turned on: base address = a1c00000
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0xe000c000 (irq = 6) is a 16550A
serial8250.0: ttyS1 at MMIO 0xe0010000 (irq = 7) is a 16550A
serial8250.0: ttyS2 at MMIO 0xe0078000 (irq = 28) is a 16550A
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
loop: loaded (max 8 devices)
lpc2xxx_eth_probe
lpc2xxx_eth_setup
get_mac_address ethaddr=00:1a:f1:00:00:00
eth0: Link down.
eth0: LPC2xxx ethernet at 0xffe00000 int=21 10-FullDuplex (00:1a:f1:00:00:00)
eth0: National DP83640 PHY at 1
Found: SST 39VF6401
lpc24xx-ea-flash: Found 1 x16 devices at 0x0 in 16-bit bank
number of JEDEC chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
Creating 2 MTD partitions on "lpc24xx-ea-flash":
0x00000000-0x00200000 : "kernel"
0x00200000-0x00800000 : "rootfs"
lpc2xxx-spi lpc2xxx-spi: registering nl2432hcc-41k
lpc24xx-ohci lpc24xx-ohci: LPC24xx OHCI
lpc24xx-ohci lpc24xx-ohci: new USB bus registered, assigned bus number 1
lpc24xx-ohci lpc24xx-ohci: irq 22, io mem 0xffe0c000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usbcore: registered new interface driver usbhid
drivers/usb/input/hid-core.c: v2.6:USB HID core driver
lpc2xxx-rtc lpc2xxx-rtc: rtc core: registered lpc2xxx-rtc as rtc0
lpc2xxx-rtc: RTC driver for NXP LPC2XXX.
i2c /dev entries driver
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 15
lpc2xxx-rtc lpc2xxx-rtc: setting the system clock to 1992-02-07 01:11:30 (697425090)
VFS: Mounted root (romfs filesystem) readonly.
Warning: unable to open an initial console.
BINFMT_FLAT: reloc outside program 0xffffffff (0 - 0xb584/0x99a0), killing sh!
Kernel panic - not syncing: Attempted to kill init!
|
